Trilas TL Máy đo khoảng cách Delta Sensor

Giá bán: Liên hệ

Hãng sản xuất: Delta Sensor

Danh mục: Máy đo khoảng cách

Nhà cung cấp: Jon & Jul Viet Nam

Xuất sứ: Pháp

Bảo hành: 12 tháng

Ứng dụng sản phẩm: Thiết bị tự động hóa

Gọi lại cho tôi

Liên hệ tư vấn

Hưng

hung@jon-jul.com

0374830598

live:.cid.7db5d206f62020e9

Thông tin sản phẩm
Thông số kỹ thuật

Trilas TL Máy đo khoảng cách Delta Sensor

1. Giới thiệu

- Trilas TL Máy đo khoảng cách Delta Sensor Hiện đang được Cty Jon-Jul phân phối rộng rãi tại thị trường Việt Nam.

2. Thông số kỹ thuật

Laser Triangulation Distance Meter
Trilas TL

Measurement up to 10 m
Optics for measurement on all kinds of surfaces
Design for extremely harsh environment
High accuracy and fast response time

Features and benefits

The Trilas TL is a digital, high resolution, non-contact laser triangulation sensor for measurement of dimensional data.
The target may be hot or cold, stationary or moving.

Sensor features and advantages :

Measurement at distances up to 10 m, measuring range up to 8 m.
High accuracy : better than 0.08 % to 0.15 % depending on the measuring range.
Fast response time : 5 ms.
2, 5 or 10 mW laser to adapt to different conditions : environment and target temperature.
Autonomous sensor : ready to use, no calibration required.
Autodiagnostic features.

By combining several sensors, dimensional measurements and shape readings can be achieved.

Typical applications


Position measurement of a slab or bloom	Width measurement

Position control - discharging of reheat furnace	Bloom, billet, bar length measurement

Straightness measurement	Coil diameter measurement decoiler - recoiler

Coil centring, diameter and height measurement	Strip loop control

Presentation

The Trilas TL is an autonomous sensor mounted in a cast aluminium housing containing a visible laser emitter with its power supply and a diode array with focalisation optics and a signal processing electronic circuit. The output of the laser beam as well as the input of the focalisation optics are each protected by a protective hood with an air connection. This avoids dust deposit or steam interference. The electrical connection is made via a connector. The sensor is delivered already equipped with the corresponding plug on silicone armoured cable (2 m standard length).
Different models of TL are available depending on laser power and measuring range.

Operating principle

The Trilas TL sensor uses the principle of optical triangulation. A diode array R observes through an optics L the image of the impact A of the emitted laser beam on the measured surface. The distance OA is related to the address N of the lighted diode of the array. The relation, depending only on the geometry of the system, is determined by a factory calibration.